Siemens 3VA1 100 A Manual page 417

Information about combination with other accessories
DIN rail adapters are normally used to install molded case circuit breakers (possibly with side
mounted residual current device) in distribution boards. The standard cover is then fitted
over the circuit breakers. The front panel (45 mm high) is the only part of the device which
protrudes through the cover. With this arrangement, it is not possible to use front mounted
accessories.
When molded case circuit breakers including DIN rail adapter are installed on rails in an
open system cubicle without a cover, it is possible to use front mounted accessories such as
motor operator, rotary operator with shaft stub, front mounted rotary operator and the front
mounted Bowden cable interlock module.
The following accessories are compatible with molded case circuit breakers and DIN rail
adapters:
3VA molded case circuit breakers
Manual, 04/2015, A5E03603177010-02
Accessories
4.14 DIN rail adapter
417