F Save & Exit; Error Codes - Fetco CBS-1131-XV+ User's Manual & Operating Manual

F SAVE & EXIT
The brewer will save changes only from the "F" menu. DO NOT reboot brewer or toggle ON/OFF-exit as below.
TO EXIT PROGRAMMING & HOW TO SAVE CONTROL SETTING CHANGES
HOW TO SAVE CHANGES AND EXIT-The brewer is in PROGAMMING mode
Programming A-F
A - F
STOP STOP
1
2
3
From any screen-
Press STOP button
until the EXIT ("F")
screen appears
NOTE: User Settings will be erased and overwritten to factory default settings by the following five programming changes
1) When setting or changing units of display for the tank temperature (F Fahrenheit or C Celsius). (SETTING B4)
2) When setting or changing units of display for the volume (G gallons, L liters).
3) When setting brewer model The software sets equipment to brewer defaults
4) When resetting (Reloading) DEFAULTS
5) When loading from USB (Reloads to defaults )

Error Codes

DO NOT CLEAR ERROR CODES UNTIL ERROR IS IDENTIFIED AND/OR CORRECTED
Contact specialized personnel for error codes

Code Description
Software error-error on start up or
001
corrupted software
050 Short-circuit in temperature probe
051 Open temperature probe.
Initial Fill Error. Initial fill time was
100 more than 11 minutes after power
up.
Error on refill
101
Tank did not refill within 3 minutes.
Heater open, high limit thermostat,
201
or Solid State Relay (SSR) fault
255 Touch pad error
NO
BSKT
Insert Brew Basket
Go to fetco.com for the latest versions of all information
Saving changes and exiting PROGRAMMING
EXIT
F NO +
STOP STOP
1
2
3
From the "F" screen
Press button 2 to
toggle to the EXIT- toggle to the SAVE
YES screen
Possible Cause
Improper start-up or
shutdown
Probe failure.
Bad probe connection, or
probe failure.
Water supply flow rate is
too low.
Water supply flow rate is
too low.
Failure of: heating element,
SSR, high Limit or low
voltage
Usually from longer than 2
min contact. Or faulty
reassembly after service
Brew basket must be in
EXIT
F YES -
STOP STOP
1
2
3
From EXIT screen From SAVE screen
Press button 1 to Press button 2, to
toggle to the SAVE-
screen
place
This is a
SAFETY FEATURE
User Guide & Operator instructions
Page 9
.
SAVE
F
STOP STOP STOP
1
2
3
To SAVE and EXIT
Press button 1 to
SAVE your changes
YES screen
(SETTING B5)
(SETTING E2)
(SETTING E5)
(SETTING E7)
Corrective Action
Restart , if still fault: reload software
Replace probe.
Check all connections. Replace probe
if necessary.
Watch for short potting during brew
cycle. Investigate cause of low flow
rate. (Clogged water filter...)
Watch for short potting during brew
cycle. Investigate cause of low flow
rate. (Clogged water filter...)
Check and replace heating elements if
necessary.
Restart , if still fault: reload software.
If mechanical: reassemble correctly
Insert brew basket into brewer rails to
enable brewer
P166 Re0
YES -
STOP
1
2
3
and EXIT
NOVEMBER 2017