F Save & Exit; Error Codes - Fetco CBS-1150 EXTRACTOR V+ User's Operation Manual

F SAVE & EXIT
The brewer will save changes only from the "F" menu. DO NOT reboot brewer or toggle ON/OFF-exit as below.
DO NOT attempt to save by rebooting (turning power OFF then ON). All changes made will be discarded and brewer will remain in the existing default settings
TO EXIT PROGRAMMING & HOW TO SAVE CONTROL SETTING CHANGES
HOW TO SAVE CHANGES AND EXIT-The brewer is in PROGAMMING mode
You may exit programming at any time. After programmed settings are saved, the brewer exits PROGRAMMING
mode and returns to regular brew operations. Settings are saved only when brewer returns to OPERATING MODE
Programming A-F
A - F
STOP STOP
1
2
3
From any screen-
Press STOP button
until the EXIT ("F")
screen appears
User Settings will be erased and overwritten to factory default settings by the following five programming changes
NOTE:
1) When setting or changing units of display for the tank temperature (F Fahrenheit or C Celsius). (SETTING B4)
2) When setting or changing units of display for the volume (G gallons, L liters).
3) When setting brewer model The software sets equipment to brewer defaults
4) When resetting (Reloading) DEFAULTS
5) When loading from USB (Reloads to defaults )

Error Codes

DO NOT CLEAR ERROR CODES UNTIL ERROR IS IDENTIFIED AND/OR CORRECTED
 Contact specialized personnel for error codes
Code Description
Software error-error on start up or
001
corrupted software
050 Short-circuit in temperature probe
051 Open temperature probe.
Initial Fill Error.
100 Initial fill time took longer than
expected after power up.
Error on refill-.
101 Tank did not refill within expected
time.
Heater open, high limit thermostat,
201
or Solid State Relay (SSR) fault
255 Touch pad error
NO
BSKT
Insert Brew Basket
Go to fetco.com for the latest versions of all information
Saving changes and exiting PROGRAMMING
EXIT
F NO +
STOP STOP
1
2
3
From the "F" screen From EXIT screen
Press button 2 to Press button 1 to
toggle to the EXIT- toggle to the SAVE
YES screen
Possible Cause
Improper start-up or
shutdown
Probe failure.
Bad probe connection, or
probe failure.
Water supply flow rate is
too low.
Water supply flow rate is
too low.
Failure of: heating element,
SSR, high Limit or low
voltage
Usually from longer than 2
min contact. Or faulty
reassembly after service
Brew basket must be in
EXIT SAVE
F1
F YES -
STOP STOP STOP
1
2
3
From SAVE screen
Press button 2, to
toggle to the SAVE-
screen
place
This is a
SAFETY FEATURE
Page 9
.
SAVE
NO +
F1
STOP STOP
1
1
2 2
3
3
To SAVE and EXIT
Press button 1 to
SAVE your changes
and EXIT to
YES screen
OPERATING MODE
(SETTING B5)
(SETTING E2)
(SETTING E5)
(SETTING E7)
Corrective Action
Restart , if still fault: reload software
Replace probe.
Check all connections. Replace probe
if necessary.
Watch for short potting during brew
cycle. Investigate cause of low flow
rate. (Clogged water filter...)
Watch for short potting during brew
cycle. Investigate cause of low flow
rate. (Clogged water filter...)
Check and replace heating elements if
necessary.
Restart , if still fault: reload software.
If mechanical: reassemble correctly
Insert brew basket into brewer rails to
enable brewer
YES -
STOP
P167 March 2018