Lights, Meters, Switches - Service Information - Honda XLR200R Service Manual

17. LIGHTS, METERS, SWITCHES
SERVICE INFORMATION ................................ 17 - 1 METER REMOVAL AND ATTACHMENT .......... 17 - 5
LOCATION OF LIGHTS, METERS & SWITCHES .. 17 - 2 METER DISMANTLING AND ASSEMBLy ........ 17 - 6
HEADLIGHT REMOVAL AND ATTACHMENT ... 17 - 3
MAIN SWITCH REMOVAL & ATTACHMENT ... 17 - 8
BULB REPLACEMENT ..................................... 17- 4
SERVICE INFORMATION
The halogen headlight bulb gets very hot while the headlight is ON. Do not touch the bulb immediately with bare hands
after turning oft. Start work only when the bulb has sufficiently cooled.
The halogen light bulb gets very hot when ON. If the bare hands or a dirty glove get in touch with the bulb during
replacement, this will leave grease or oil on the bulb surface. This will then become a "hot spot" which can cause cracking
on·or damage to the bulb surface. Pay careful attention to the following when replacing the bulb.
-Do not replace while bulb is ON. Always turn the main switch OFF, and wait for the bulb to cool.
-Use clean gloves when replacing the bulb, and make sure that no oil grease adheres to bulb surface.
-If the grease or oil adheres to bulb surfaces, use alcohol or thinner with clean cloth to remove the grease or oil.
-After replacing bulb,
fe-attach
the dust cover.
If battery will be used in testing, make sure that the battery is not defective.
Con~inuity
tests for switches may be done while switches are attached on the vehicle (no need to remove or dismantle).
17-1
m