Specifications; Printer - Toshiba B-FV4T-GS12-QM-R Owner's Manual

6 Specifications
This chapter provides specifications for the printer.
6.1 Printer
Model
Print method
Resolution
Media Alignment
Operation Mode
Sensor
Print Speed
Print Darkness
Max Printable Area
Non‐Printable Area
Print Ratio
Interface
Optional Interface
Accessories
On‐Board Memory
External Memory
Panel
LED
Font
B‐FV4T‐GS12‐QM‐R B‐FV4T‐GS12‐CN‐R B‐FV4T‐TS12‐QM‐R B‐FV4T‐TS12‐CN‐R
203 dpi (8 dots/mm)
Standard: Continuous mode, Tear‐off mode
Media Sensor: Gap Sensor (Transmissive, Fixed)
2, 3, 4, 5, 6 inches/sec
(50.8, 76.2, 101.6, 127, 152.4 mm/sec)
2 &3ips for peel off mode
Length 999 mm x Width 108 mm
Pitch Direction ‐ Top: 1 mm, Bottom: 1 mm (excluding liner)
Width Direction ‐ Left: 1 mm, Right: 1 mm (excluding liner)
Average print ratio within 15 % or less (whole print layout area)
Peeler, Full Cutter, Partial Cutter, RTC, External Media Stand
Standard Memory (Flash ROM): 16 MB
st
1 LED: Red and Green (Various Combinations: Orange)
nd
2 LED: Red and Green (Various Combinations: Orange)
Standard: See the TEC Command Reference
Extended: Download with Printer Utility
Direct Thermal and Thermal Transfer
Centered
Optional: Cutter mode, Peeler mode
I‐Mark Sensor (Reflective, Movable)
Head Open Switch
Ribbon Sensor
Darkness level: ‐10 ~ +10
Default: 0
Full width with 1mm pitch is required
USB (Type A and Type B), Ethernet
RS‐232C, Centronics (SPP Mode)
User Memory: 2 MB
Standard Memory (SDRAM): 32 MB
USB: Max 16 GB
2 LED, 1 Button
‐ 39 ‐
300 dpi (12 dots/mm)
2, 3, 4 inches/sec
(50.8, 76.2, 101.6 mm/sec)
2 &3ips for peel off mode
Length 999 mm x Width 105.7 mm
B‐FV700‐BLTH‐QM‐R