Filter Combination With Microfine Filter; Figure 050-15: Middle And Bottom Spray Arm Sensors - Miele G 4205 Technical Information

Technical Information

Figure 050-15: Middle and Bottom Spray Arm Sensors

2.18

Filter Combination with Microfine Filter

Circulation pump M6 pumps the wash water from the sump via the filter
combination to the spray arms. The circulating wash water is filtered via 2
parallel paths. A proportion of the water flows through the central opening of
the coarse filter and then passes through the conical microfine filter (Figure
050-16, Item 3). The remainder passes directly through the large surface
area fine filter (Figure 050-16, Item 2), which contains a small hole for
ventilation of the suction area of the circulation pump. Both partial currents
are continually redistributed via constant circulation in the cabinet, so that all
suds flow through the microfine filter. Soil that is retained by the microfine
filter either collects there or falls onto the filter cap where it will eventually be
flushed out by the drain pump.
The crown coarse filter (Figure 050-16, Item 1) is attached to the filter
combination handle. If dispensed powder detergent should fall into the
microfine filter, it remains on the filter cap where it can dissolve. This prevents
it from collecting in the drain outlet. Foreign objects which pass the crown
1 Spray arm sensor, middle spray arm
2 Spray arm sensor, bottom spray arm
90
G 5xxx