Avaya Integral 3 / 5 FC1 User Manual page 20

Getting to know your handset Important information
eas of the battery must get into electrical contact with the contact springs.
Close the lid. As soon as the contact is established and charging starts, the
front bottom LED of the table-top charger changes its colour from green to
red.
Charging an explosion-proof battery using the Tischladegerät FC1 S Ex
An open bay is provided on the back of the table-top charger Tischla-
degerät FC1 S Ex for charging an explosion-proof spare battery. Place the
battery into the bay with the contacts facing downward and the securing
screw bore facing outside and gently press it down against the contact
springs. As soon as the contact is established and charging starts, the front
bottom LED of the table-top charger changes its colour from green to red.
For more information about handling explosion-proof handset versions
and for safety instructions when replacing the battery see the "Quick
Guide" coming with the handset.
Information on using the battery
ATTENTION
Do not throw the battery into a fire as it might explode.
To avoid injury and fire damage, do not allow the contacts of the bat-
tery to come into contact with conductive objects or to be short-
circuited.
When you first load a new battery, the handset does not at first "know" its
charging status. So, for the time being, the battery signal shows two bars only
meaning battery is nearly charged. An appropriate battery signal will be shown
after the battery pack once has been completely charged in the handset!
Every time you insert a battery pack into your handset, you should charge
the battery to full capacity for at least 14 hours. Use only system-compatible
chargers for charging the batteries!
Read the hints about "Caring for NiCD and NiMH battey packs" in the Quick
Guide. They contain information on how to obtain optimum service life from
your battery pack.
20
(V 1.6 - 08/2004)
(V 2.0 - 07/2007)
FC1 / FC1 Ex