Table of Contents
Advertisement
TO INSTALL BAGGER COM PO NENTS TO
TRAC TOR (See Figs. 4A-4D)
•
Remove discharge chute from rear of tractor. Unhook
the two (2) straps and pull chute out and away from
tractor.
•
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
DISCHARGE
CHUTE
3/8 NUT
FLATWASHER
•
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
SUP PORT
TUBE
FLAT
WASHER
3/8 NUT
BOLT
•
Install the two upper support brack ets through the back
plate and to the chas sis, install the clevis pin 10x17mm
and secure with retainer spring.
•
Assemble both support brackets to the outside of the
bagger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. flat washers and 3/8 locknuts from parts
bag. Tight en securely.
ASSEMBLY
Fig. 4A
Fig. 4B
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
CLEVIS PIN 10 X 17MM
3/8 LOCK NUT
SUPPORT BRACKET
10,3MM (13/32")
FLAT WASHER
3/8 X 63,5MM HEX BOLT
RETAINER SPRING
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to float with the
mower deck when moving on uneven terrain.
TO ASSEMBLE BAGGER (See Figs. 5A-5C)
•
Unfold bag by pivoting front bagger tube all the way
forward and pressing the bottom vinyl binding onto the
tube.
•
Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
•
Press the vinyl bindings onto the sides of front bagger
tube.
•
Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin 10 x 44mm and secure
with retainer spring.
FRONT BAGGER TUBE
VINYL BINDING
8
Fig. 4C
DIS CHARGE
CHUTE
HOOK
BACKPLATE
SLOT
Fig. 4D
Fig. 5A
Advertisement
Table of Contents
