•
First connect RED battery cable to positive (+) ter-
minal with hex bolt and keps nut as shown. Tighten
securely.
•
Connect BLACK grounding cable to negative (-) ter-
minal with remaining hex bolt and keps nut. Tighten
securely.
•
Replace battery cover.
Open battery cover for:
•
Inspection for secure connections (to tighten hard-
ware).
•
Inspection for corrosion.
•
Testing battery.
•
Jumping (if required).
•
Periodic charging .
BATTERY
COVER
DISCARD TERMINAL
PROTECTIVE CAPS
HEX BOLT
POSITIVE CABLE
(RED)
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
•
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached
which allows you to press clutch/brake pedal all the
way down.
•
Get off seat without moving its ad just ed position.
•
Raise seat and tighten adjustment knob securely.
ASSEMBLY
NEGATIVE
CABLE (BLACK)
KEPS
NUT
Fig. 2
SEAT PAN
FLAT WASH ER
AD JUST MENT KNOB
NOTE: You may now roll your tractor off the skid. Follow
the ap pro pri ate instruction below to remove the tractor
from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
•
Press lift lever plunger and raise attachment lift lever
to its highest po si tion.
•
Release parking brake by de press ing clutch/brake
ped al.
•
Place freewheel control in "trans mis sion dis en gaged
position" (See "TO TRANS PORT" in the Op er a tion
section of this manual).
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor.
7
SEAT
SHOUL DER BOLT
02464
Fig. 3