Samsung AM160FNBDEH Installation Manual page 4

SEVERE WARNING SIGNS
Installation must be requested to a qualified installer.
If the user installs a product improperly on their own, it may cause refrigerant leakage and lead to electric shock or fire in
worst case scenario.
Install the unit in a place where it is strong enough to hold the product weight.
When installed in place where it is not strong enough to withhold the product weight, the unit could fall and cause injury.
Do not put any product or object under the DVM Hydro unit / Hydro unit HT.
Water from the DVM Hydro unit / Hydro unit HT may fall and cause fire or loss of property.
Electric work must be done by qualified persons, complying the national wiring regulations and installed according to the
instruction stated in the installation manual with leased circuit.
Capacity shortage on the leased circuit and improper installation may cause electric shock or fire.
Use specified wires to connect the DVM Hydro unit / Hydro unit HT and outdoor unit, and make sure the wire is firmly fixed.
Improper connection may cause fire.
Neatly arrange the wires in the electrical parts to make sure that electrical cover is closed securely without any gap.
If the cover is not properly closed, heat may generate on the electrical terminal and cause electric shock or fire.
Make sure to use the provided or specified parts with the specified tools for installation.
Failing to do so may cause product failure, refrigerant leakage, fire or electric shock.
In any case of refrigerant leakage, make sure to ventilate.
If the refrigerant gas comes in contact with fire, harmful gas will be generated.
Make sure that the refrigerant gas does not leak after completing the installation. If the refrigerant gas of the indoor unit
leaks and comes into contact with the fan heater, space heater or stove, harmful gas will be generated.
Make sure to perform grounding work.
Do not connect the ground wire to a gas pipe, water pipe, lightning rod or telephone grounding. Improper grounding
could cause electric shock.
Do not install the product in a place where it is or might be exposed to inflammable gas leakage.
When the gas leaks and gets accumulated around the product, it may cause fire.
Installation work must be done according to the instruction in this installation manual.
Improper installation may cause water leakage, electric shock or fire.
When inserting the power plug, make sure to insert it fully and check that power plug and a consent does not have any dusts,
blockage or loosened part.
If there are dusts, blockage or loosened part on a power plug or consent, it can cause electric shock or fire. Also, replace
the consent if it is loosened.
When installation is in progress, check the following before operating the product.
Make sure pipes are properly connected without any leakage.
When there is leakage on the connected part, air may get in and cause abnormally high pressure state which may lead to
pipe explosion and personal injury.
Do not assemble the power cord on your own, use two cables together to extend the cable length or connect the power to a
multi consent connected with other products.
Bad connection, isolation and over voltage may cause fire or electric shock.
Cut-off the main power supply before electrical installation of DVM Hydro unit / Hydro unit HT.
Potential risk or electric shock.
You may need to install an ELB (earth leakage breaker) depending on the installation location.
Not installing an ELB (earth leakage breaker) may cause electric shock.
Supply power to the product during winter time since the product will operate in protection mode itself when the
temperature decrease below 0 °C.
If you cut-off the power, protection mode cannot be operated and may cause damage to the product.
DVM Hydro unit / Hydro unit HT is designed to be installed indoor. Make sure to install it in a place where there is no risk
of surrounding temperature from dropping below zero.
3