Table of Contents
Advertisement
WARNING! If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal injury
I
or death.
WHAT
TO DO IF
YOU SMELL
GAS
•
Do
not try to light
any
appliance
•
Do not
touch
any
electrical switch
•
Do not
use any phone in
your building
•
Immediately call
~r
gas
supplier
from
a neighbors
phone. Follow the
gas supplier's
instructions.
•
If
you
can
not
reach
your
gas supplier,
call the
fire department
Installation and service
must be performed by a
qualified installer, service agency or
the gas supplier.
The
appliance and its individual shutoff valve must
be disconnected from the gas supply
piping
system during any pressure testing of that system
test pressures in excess of 5
psi
(35 kpa).
The appliance must be isolated from the gas supply
piping
system by closing its individual manual
shutoff valve during any pressure testing of the
gas supply piping system at test
pressures
equal
or
less
than 5 psi (35 kpa).
RNING! Disconnect Power before installing.
fore turning power ON, be sure that all
ntrols are in the OFF position.
IMPORTANT! Installation must
conform with local
codes or, in
the
absence of
local codes, with the
National fuel Gas
Code,
ANSI
Z223.1/NFPA54.
•
Smother
flames with
a close
fitting lid, or any
metal tray.
•
Turn
OFF
the burner.
Be
careful
to prevent burns.
If
the
flames
do
not extinguish, immediately
evacuate and call the fire department
•
NEVER pick
up a flaming
pan. By
doing so,
you
may
be
burned.
•
DO
NOT use water or a wet dishcloth on fire.
A violent steam explosion will result. Use a fire
extinguisher only if:
•
You
have
CLASS
ABC
extinguisher
and
you know how to operate it.
•
The fire is small and contained in the
area where it started.
•
The fire department has been
called.
•
You can fight the fire Wth
your
back
to
the
exit.
FOR YOUR
SAFETY! ifYou Smell
Gas:
Shut
off gas
to
the
appliance.
Extinguish
any
open
flames.
if odor persists, immediately
call
your
gas supplier.
This
appliance
is
designed
for
ease
of
installation and operation.
However,
we
recommend that you
read
all sections of
this
manual before installation
and that your range
is installed by an approved gas installation
technician capable
~
reviewing and performing
the
manufacturers installation checklist included
in your information packet.
The installation of appliances assigned for
manufactured (mobile) home installation must
conform with the Manufactured Home Construction
and Safety and SafetyStandard,litle 24 CFR,
Part
3280 or, when such standard is not applicable,
the Standard for
Manufactured Home
Installations, ANSI/NCSBCS
A225.1, or with
local codes as applicable.
The
installation of
appliances designed for
Recreation Park Trailers
must conform
with state
or other
codes or, in the absence of such
codes,
with the standard for
Recreational Park Trailers,
ANSI A119.5.
The appliance, when installed, must
be
electrically
grounded in accordance with local codes or, in
the absence of local codes, with the
National
WARNINGS!
Electrical
Code,
ANSI/NFPA
70
I
WARNING! If the information in this manual is
I
not followed exactly, a fire or explosion may
result, causing property damage, personal injury·
or death. Please read the installation, operating
I
and maintenance instructioos th<roughly
before
use.
CAUTION! When connecting the unit to
propane gas, make certain the propane tank is
equipped with its own high-pressure regulator
in addition to the pressure regulator supplied
with the range. The pressure of the gas
supplied to the appliance must not exceed
14
"
(34.57 mB) water column from the propane
gas tank to the pressure regulator.
CAUTION! Do not store or use gasoline or any
other flammable liquids in the vicinity of this or
any other appliance.
THIS
FUTURE
PLEASE RETAIN
MANUAL FOR
RE FERENCE!
PLEASE NOTE:
In
the Commonwealth of Massachusetts, gas
connection must be performed by a licensed
plumber or
licensed
gas fitter.
I MPORTANT!: For
fire safety and correct operation
a back guard must
be installed on all ranges prior
to use!
All ranges are
shipped
with
a
standard
3" Island
Trim
which is
compatible
with non-combustible
back wall
installations ONLY!
If
desired or
if the minimum
distance to
a combustible back
wall
in
not met
(see Fig. 2A) one of two
additional
back guards heights
may
be ordered and installed (Low
Back
-
9",
or
High Back
- 18'1.
Refer
to the Installation Instructions
accompanying this appliance for assembly instructions
Advertisement
Chapters
Table of Contents
