Diagnostic Load Progress Indicators - IBM R30 Operator's Manual

Diagnostic Load Progress Indicators

The following dump progress indicators, or dump status codes, are part of a Type 102
message.
Note: When a lowercase c is listed, it displays in the lower half of the seven-segment
character position. The leftmost position is blank on the following codes.
0c0
0c2
0c3
0c4
0c5
0c6
0c7
0c8
0c9
E-12
Operator Guide
The dump completed successfully.
A dump, requested by the user, is started.
The dump is inhibited.
The dump did not complete. A partial dump may be present.
The dump program could not access the dump device.
A dump to the secondary dump device was requested. Make the secondary
dump device ready; then press Ctrl-Alt-Numpad2.
Reserved.
The dump function is disabled.
A dump is in progress.