Creating Cover Labels - IBM R30 Operator's Manual

Creating Cover Labels

Note: Either a 5.0GB 8 mm tape drive or a 4.0GB 4 mm tape drive can be installed in the
right media position.
Use the following steps and the sheet of peel-off numbers supplied with your system to
create cover labels for SCSI drawers.
1. Remove the cover from the SCSI drawer by grasping the cover on both sides and pulling
out from the drawer.
2. Look at the drawer ID label located in the lower-left corner of the drawer. The digits on
this label are the first two digits of each cover label.
Drawer ID Label
3. Apply the digits that represent the drawer ID to the left corner of each cover label.
For example: If the drawer ID is 02, apply 02 to the left corner of each cover label.
0 2
4-16
Operator Guide
0 2
0 2
Cover
Cover Label
0 2