Optional) Setting Hwtacacs Timers; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

1 AAA and User Management Configuration
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
hwtacacs-server template template-name
The HWTACACS server template view is displayed.
Step 3 Run:
hwtacacs-server traffic-unit { byte | kbyte | mbyte | gbyte }
The traffic unit is set for an HWTACACS server.
By default, the traffic is expressed in bytes on the S9300.
----End

1.6.9 (Optional) Setting HWTACACS Timers

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
hwtacacs-server template template-name
The HWTACACS server template view is displayed.
Step 3 Run:
hwtacacs-server timer response-timeout
The timeout interval for an HWTACACS server to send response packets is set.
By default, the timeout interval for an HWTACACS server to send response packets is five
seconds.
If the S9300 receives no response from an HWTACACS server during the timeout interval, it
considers the HWTACACS server as unavailable. In this case, the S9300 performs
authentication or authorization in other modes.
Step 4 Run:
hwtacacs-server timer quiet value
The time taken to restore an HWTACACS server to the active state is set.
By default, the time taken by the primary HWTACACS server to restore to the active state is
five minutes.
----End

1.6.10 Checking the Configuration

1-26 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
Issue 01 (2009-07-28)