Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

1 AAA and User Management Configuration
1.5.2 Creating a RADIUS Server Template
1.5.3 Configuring a RADIUS Authentication Server
1.5.4 (Optional) Configuring the Protocol Version of the RADIUS Server
1.5.5 (Optional) Setting a Shared Key for a RADIUS Server
1.5.6 (Optional) Setting the User Name Format Supported by a RADIUS Server
1.5.7 (Optional) Setting the Traffic Unit for a RADIUS Server
1.5.8 (Optional) Setting Retransmission Parameters on a RADIUS Server
1.5.9 Checking the Configuration

1.5.1 Establishing the Configuration Task

Applicable Environment
In remote authentication or authorization mode, you need to configure a server template as
required. You need to configure a RADIUS server template if RADIUS is used in the
authentication scheme.
Pre-configuration Tasks
None
Data Preparation
To configure a RADIUS server template, you need the following data.
No.
1
2
3
4
5
1-16
NOTE
There are default parameters of a RADIUS server template, and the default parameters can be changed
according to the networking. You can modify the RADIUS configuration only when the RADIUS server
template is not in use.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
Data
IP address of the RADIUS authentication
server
(Optional) Protocol version of the RADIUS
server
(Optional) Shared key of the RADIUS server
(Optional) User name format supported by
the RADIUS server
(Optional) Traffic unit of the RADIUS server
Issue 01 (2009-07-28)