Cutter Cannot Detect Hp Barcode Or Registration Marks - HP 54 Basic Cutter User Manual

4. Try reducing the cutting speed. If you cut too fast, the substrate may not have time to fold correctly in the
basket.
5. Your jobs may be too long, causing problems in the basket. Try dividing jobs into shorter segments, such as
one-meter panels.

Cutter cannot detect HP barcode or registration marks

1. Ensure that you position the cutting head correctly when the cutter prompts you to do so. Carefully read
the instructions on the cutter's screen when starting a cutting job.
2. This problem most often occurs with substrates that are colored or have certain laminations. Remember to
calibrate the substrate before using it. See
3. Check whether the sensor touches the substrate during barcode and marker detection.
Calibrate the OPOS sensor
1. Turn on the cutter and load black vinyl with white backing.
IMPORTANT:
calibration setting should be set to the default value.
2. Set the head's origin above a clean, blank part of the vinyl.
3.
Press
4.
Press
5.
Press
6.
Press
square measuring approximately 9.5 × 9.5 mm and move the square forward. Weed rectangle appears on
the screen.
7.
Carefully weed the square, making sure the edges stay intact. Press
square and calibrates itself accordingly.
NOTE: To maintain the accuracy of the OPOS sensor, repeat this calibration whenever you install a knife.
48 Chapter 7 Troubleshooting
Black vinyl with white backing must be used when calibrating OPOS. The substrate
.
. System setup appears on the screen. Press
or until you reach Calibrations. Press
or to scroll through the menu until you reach Cal OPOS. Press
Calibrate the substrate on page
.
.
17.
. The cutter cuts out a
. OPOS reads the edges of the
ENWW