Cut Types; Detailed Opos Operations - HP 54 Basic Cutter User Manual

Cut types

The cutter is designed to make two kinds of cut:
Kiss cut: This cuts only the substrate, and not the liner
●
Cut through (called FlexCut in the cutter's front panel): This cuts all the way through the substrate and liner.
●
Small pieces left uncut (bridges) allow the substrate to remain connected together; when the job is finished,
the cut pieces can be torn out. Although this can be done with any shape, it is reliable only with simple
shapes. See

Detailed OPOS operations

Load the print into the cutter
Load the print into the cutter as usual (see
origin, is situated at the bottom right corner of the cutter.
28 Chapter 4 Cut the substrate
Cut through on page 30.
Load the substrate on page 12). Make sure the marker, indicating the
ENWW