HP 54 Basic Cutter User Manual page 19

8. Make sure the substrate follows a straight path from the roll. If necessary, slide the roll and flange guides
from left to right along the substrate support rollers.
WARNING!
moving parts.
9. Lower the pinch-roller lever to press the substrate firmly against the drive sleeves. After one second the
tool carriage automatically moves from right to left to measure the usable substrate width.
NOTE:
substrate automatically as needed.
Load a sheet
1. Place the sheet in front of the cutter, and make sure that it is correctly aligned, using the alignment marks
at front and rear.
2. Raise the pinch rollers with the pinch-roller lever arm, which is located at the right-hand side of the cutter,
next to the front panel.
3. Start feeding the substrate in from the rear of the machine. Pass the substrate underneath the pinch rollers
towards the front of the cutter.
4. Position the left substrate edge on the leftmost drive sleeve and check that the right substrate edge is
positioned over the long drive sleeve.
NOTE:
positions on page
ENWW
Keep fingers and other body parts away from the cutting area, where there are hazardous
You are not recommended to unroll the substrate manually from the roll. The cutter will unroll the
If you have the HP 54 Basic Cutter, load the substrate as shown in
14.
HP 54 Basic Cutter loading
15