HP 54 Basic Cutter User Manual page 33

Change the OPOS settings manually
1. Turn on the cutter.
2.
Press
3.
Press
4.
Press
5.
Press
6.
Press
OPOS origin, Sheet mode,and Panels.
7.
Press
8.
Press
9.
Press
10.
Press
Register the markers
Most cutting software will initiate the special load procedure after the parameters are sent. If the software does
not do this, initiate the loading sequence from the cutter's front panel.
Register the markers manually
1. Turn on the cutter and load the substrate.
2.
Press
3.
Press
4.
Press
5.
Press
prompting you to set the knife above the first marker scrolls across the screen.
6.
Use
7. Press
Then it reads the markers.
NOTE:
NOTE:
message is displayed: Markers could not be sensed, press
ENWW
.
. System setup appears on the screen. Press
or to scroll through the menu until you reach Configuration. Press
or to scroll through the menu until you reach OPOS parameters. Press
or to choose the parameter to be changed or checked. The available parameters are
to confirm. The value of the chosen parameter appears on the screen.
or to change the parameter value.
to confirm. An asterisk appears by the value, indicating that it is now selected.
once to choose another parameter, or twice to leave the menu.
.
. System setup appears on the screen. Press
or to scroll through the menu until you reach Actions. Press
or to scroll through the menu until you reach Media alignment. Press
, , , and
. The cutter reload the substrate to check that the loaded length matches the OPOS parameters.
If a marker cannot be read, you can reposition the knife and try again, or cancel the operation.
If an error occurs or the cutter cannot read the markers after three attempts, the following
to position the knife.
.
.
.
to continue.
Detailed OPOS operations
.
.
. A message
29