Advertisement
ASSEMBLY INSTRUCTIONS
5
6
8
STEP 5:
Once the front legs of the Trampoline
have been assembled and the Arch handle
properly installed, you may begin putting
together the parts for the back legs of the
trampoline. You will need the following
Parts: Short Bolt (Part G), Spacers (Part
J), Washers (Part I), and Nuts (Part H).
Follow the order shown below to properly
assemble the legs.
Make sure to insert the Bolt into Frame
Leg with Square Opening to keep part
secure and in place, with remainder of bolt
sticking out from Frame Leg with Round
Opening once all parts are in order. This
will allow you to place the washer and Nut
properly.
NOTE:
You might need another adult to help you in
this section. The tension from the Jumping
Mat will make it difficult for parts to stay in
place. Having someone to hold all the parts
together while installing the legs can be
helpful.
NOTE:
Do not tighten Nuts until beginning of step
6. This will avoid too much tension on legs.
STEP 6:
Once all legs are properly installed, you
may begin to tighten the Nuts to ensure
they are properly attached and secure.
Doing so will give you enough space to
place the Black Cap (Part K).
NOTE:
Make sure to place all 8 Black Caps on the
bolts. Failure to inspect that all parts are
properly installed on the product before
use, can cause injury, scratches, and/or
cuts.
GQBrands.com
CustomerService@GQBrands.com
1-866-498-5269
Advertisement
