Advertisement
ASSEMBLY INSTRUCTIONS
3
4
9001KJ
STEP 3:
Grab Handle Arch - Female (Part D/F) and
Handle Arch - Male (Part D/M) and connect
them to form the arch handle. The Handle
Arch - Male, has a snap button that must
be pressed and pushed when sliding into
the Handle Arch -Female. You will hear a
"click" when the button has properly locked
into the hole.
To avoid pinching when in use, push foams
into each other at the top of the arches to
cover completely the connecting area.
STEP 4:
To connect all trampoline legs and arch
legs in the front of the trampoline, you will
need the following Parts: Long Bolt (Part
F), Spacers (Part J), Washers (Part I), and
Nuts (Part H). Follow the order shown to
properly assemble the legs.
Make sure to insert the Bolt into Frame
Leg with Square Opening to keep part
secure and in place, with remainder of bolt
sticking out from Frame Leg with Round
Opening once all parts are in order. This
will allow you to place the Washer and Nut
properly.
NOTE:
You might need another adult to help you in
this section. The tension from the Jumping
Mat will make it difficult for parts to stay in
place. Having someone to hold all the parts
together while installing the legs can be
helpful.
NOTE:
Do not tighten Nuts until beginning of step
6. This will avoid too much tension on legs.
7
Advertisement
