Operation - Poulan Pro 545186756 Instruction Manual

WARNING:
Before using chain
saw, ensure all fasteners are secure.
CARTON CONTENTS
S Chain Saw (fully assembled)
S Bar Sheath
Examine parts for damage. Do not use
damaged parts.
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
Compare the illustrations with your unit to familiarize yourself with the loca-
CHAIN SAW.
tion of the various controls and adjustments. Save this manual for future reference.
Bar Oil Cap
Trigger Lockout
Button
Power
Cord
TRIGGER SWITCH
The is used to turn on
TRIGGER SWITCH
the unit. Squeeze the trigger switch to
operate the unit after lock--out button
has been pushed forward. Release the
trigger to turn the unit off.
TRIGGER LOCK- -OUT BUTTON
The
TRIGGER LOCK- -OUT BUTTON
control feature designed to prevent the
motor from being accidently started.
When the rear handle is gripped in a nor-
mal cutting position, the lock--out button
can be pushed in by the thumb, permit-
ting the index finger to squeeze the trig-
ger. It is not necessary to maintain pres-
sure on the lock--out button once the
trigger has been engaged.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified on
your unit.
SELECT AN EXTENSION CORD
MINIMUM WIRE GAUGE
RECOMMENDATIONS
25 ft. 50 ft.
Volts
(7.67 m) (15.24 m)
14 12
120
A.W.G.* A.W.G.* RECOMMENDED
*American Wire Gauge
ASSEMBLY
NOTE: If you need assistance or find that
parts are missing or damaged, please call
1-800-554-6723.
ASSEMBLY
Your unit is fully assembled; no assembly
is required.

OPERATION

Chain Adjustment Screw
Trigger Switch Bar Clamp
BAR OIL CAP
The
BAR OIL CAP
tank.
CHAIN ADJUSTMENT SCREW
The
CHAIN ADJUSTMENT SCREW
used to adjust the chain tension.
POWER CORD
is a
The
POWER CORD
the chain saw to an approved extension
cord.
CHAIN TENSION
It is normal for a new chain to stretch dur-
ing first 15 minutes of operation. You
should check your chain tension frequent-
ly. See
CHAIN TENSION
VICE AND ADJUSTMENTS
ATTACH THE EXTENSION CORD TO
YOUR CHAIN SAW
To prevent disconnection from unit, se-
cure extension cord to power cord as
shown in the following illustration.
Power Cord
100 ft.
(30.48 m)
NOT
7
Handguard
Bar
Chain
is used to fill the bar oil
is used to connect
under the
SER-
section.
Extension Cord
is