Operation - Poulan Pro 545117546 Instruction Manual

KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
Compare the illustrations with your unit to familiarize yourself with the
CHAIN SAW.
location of the various controls and adjustments. Save this manual for future refer-
ence.
Oiler Actuator/
Bar Oil Cap
Lock- -out
Button
TRIGGER SWITCH
The is used to turn on
TRIGGER SWITCH
the unit. Squeeze the trigger switch to
operate the unit after lock--out button
has been pushed in. Release the trigger
to turn the unit off.
TRIGGER LOCK- -OUT BUTTON
The
TRIGGER LOCK- -OUT BUTTON
control feature designed to prevent the
motor from being accidently started.
When the rear handle is gripped in a
normal cutting position, the trigger
lock--out button can be pushed in by
the thumb, permitting the index finger
to squeeze the trigger. It is not neces-
sary to maintain pressure on the trig-
ger lock--out button once the trigger
has been engaged.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified on
your unit.
SELECT AN EXTENSION CORD
MINIMUM WIRE GAUGE
RECOMMENDATIONS
50 ft.
25 ft.
Volts
(15.24 m)
(7.67 m)
16 16
120
A.W.G.* A.W.G.*
*American Wire Gauge

OPERATION

Chain Adjustment
Screw
Trigger Switch
Power Cord
BAR OIL CAP/OILER ACTUATOR
The
BAR OIL CAP
bar oil tank and pressed to supply oil to
chain.
CHAIN ADJUSTMENT SCREW
The
CHAIN ADJUSTMENT SCREW
used to adjust the chain tension.
is a POWER CORD
The
POWER CORD
the chain saw to an approved extension
cord.
CHAIN TENSION
It is normal for a new chain to stretch dur-
ing first 15 minutes of operation. You
should check your chain tension fre-
quently. Readjust chain after every 15
minutes of operation. See
under the
TENSION
tion.
ATTACH THE EXTENSION CORD TO
YOUR CHAIN SAW
To prevent disconnection from unit, se-
cure extension cord to power cord as
shown in the following illustration.
Power Cord
100 ft.
(30.48 m)
14
A.W.G.*
7
Bar Sprocket
Hole
Chain
Bar
is used to access the
is
is used to connect
CHECK CHAIN
sec-
MAINTENANCE
Extension Cord