Check Chain Tension - Poulan Pro 545117546 Instruction Manual

S Oil Tank -- Discontinue use of chain
saw if oil tank shows signs of damage
or leaks.
S Power Cord -- Discontinue use if chain
saw power cord shows signs of dam-
age or wear.
CHECK FOR LOOSE
FASTENERS AND PARTS
S Bar Mounting Nut
S Chain
S Bar Adjusting Screw

CHECK CHAIN TENSION

WARNING:
Wear
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
Chain tension is very important. Chain
stretches during use. This is especially
true during the first few times you use your
saw. Always check chain tension each
time you use your saw.
1. Unplug unit from the power source.
2. Use a screwdriver to move chain
around guide bar to ensure kinks do
not exist. The chain should rotate
freely.
NOTE: It is recommended that the saw
be turned upside down for chain
tensioning.
3. Loosen bar mounting nuts until they
are finger tight.
4. Turn the adjusting screw clockwise
until the chain solidly contacts bot-
tom of guide bar rail. Then, turn ad-
justing screw an additional 1/4 turn.
This is correct chain tension setting.
Adjusting Screw - - 1/4 Turn
NOTE: To tighten the chain, turn the
adjusting screw clockwise; to loosen the
chain, turn the adjusting screw counter-
clockwise.
Adjusting Screw
5. Check the tension by lifting the chain
from the guide bar. Remove some of
the stiffness in the chain by pulling
down on the chain several times.
6. Continue
screw until the tension is correct
(see step 4).
protective
7. Tighten bar mounting nuts with a
wrench.
8. Recheck chain tension.
WARNING:
with a loose chain, the chain could jump
off the guide bar and result in serious in-
jury.
CHECK CHAIN SHARPNESS
A sharp chain makes wood chips. A dull
chain makes a sawdust powder and
cuts slowly. See
the
SERVICE AND ADJUSTMENTS
CHECK GUIDE BAR
Conditions which require guide bar
maintenance:
S Saw cuts to one side or at an angle.
S Saw has to be forced through the cut.
S Inadequate supply of oil to the bar and
chain.
Check the condition of the guide bar
each time the chain is sharpened. A
worn guide bar will damage the chain
and make cutting difficult.
After each use, with unit disconnected
from power source, clean all sawdust
from the guide bar and sprocket hole.
To maintain guide bar:
S Disconnect the chain saw from the
power source.
S Loosen and remove bar mounting
nuts. Remove bar, bar clamp plate
and chain from saw.
S Clean the oil holes and bar groove af-
ter each 5 hours of operation.
Oil Holes
S Burring of guide bar rails is a normal
process of rail wear. Remove these
burrs with a flat file.
S When rail top is uneven, use a flat file
to restore square edges and sides.
12
turning the adjusting
If the saw is operated
in
CHAIN SHARPENING
section.
Remove Sawdust From
Guide Bar Groove