Configuring A Broadcast Limit On The Switch - ProCurve 2910al-24g Management And Configuration Manual

ProCurve(config)# no int 7-10 flow-control
ProCurve(config)# show int brief
Status and Counters - Port Status
Port Type
------- --------- + --------- ------- ------ ---------- ----- ----- ------
1 100/1000T | No
2 100/1000T | No
3 100/1000T | No
4 100/1000T | No
5 100/1000T | No
6 100/1000T | No
7-Trk1 100/1000T | No
8-Trk1 100/1000T | No
9-Trk2 100/1000T | No
10-Trk2 100/1000T | No
11 100/1000T | No
Figure 10-11. Example Continued from Figure 10-10
| Intrusion
| Alert Enabled Status Mode
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes

Configuring a Broadcast Limit on the Switch

Broadcast-Limit on switches covered in this guide is configured on a per-port
basis. You must be at the port context level for this command to work, for
example:
ProCurve(config)#int B1
ProCurve(int B1)# broadcast-limit 1
Broadcast-Limit.
Syntax: broadcast-limit <0-99>
Enables or disables broadcast limiting for outbound
broadcasts on a selected port on the switch. The value selected
is the percentage of traffic allowed, for example, broadcast-limit
5 allows 5% of the maximum amount of traffic for that port. A
value of zero disables broadcast limiting for that port.
Note: You must switch to port context level before issuing the
broadcast-limit command.
Note: This feature is not appropriate for networks requiring
high levels of IPX or RIP broadcast traffic.
Viewing Port Status and Configuring Port Parameters
Down 1000FDx
Down 1000FDx
Down 1000FDx
Down 1000FDx
Down 1000FDx
Up 1000FDx
Up 1000FDx
Up 1000FDx
Up 1000FDx
Up 1000FDx
Up 1000FDx
Port Status and Configuration
MDI Flow Bcast
Mode Ctrl Limit
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
Auto off 0
10-17