ProCurve 2910al-24g Management And Configuration Manual page 209

Figure 9-16. Example of Enabling TimeP Operation in DHCP Mode
Enabling TimeP in DHCP Mode. Because the switch provides a TimeP
polling interval (default: 720 minutes), you need only these two commands for
a minimal TimeP DHCP configuration:
Syntax: timesync timep
Selects TimeP as the time synchronization method.
Syntax: ip timep dhcp
Configures DHCP as the TimeP mode.
For example, suppose:
Time synchronization is configured for SNTP.
■
■ You want to:
1. View the current time synchronization.
2. Select TimeP as the time synchronization mode.
3. Enable TimeP for DHCP mode.
4. View the TimeP configuration.
The commands and output would appear as follows:
show timep displays the TimeP configuration and also shows
1
that SNTP is the currently active time synchronization mode.
3
4
show timep again displays the TimeP configuration and shows that TimeP is
now the currently active time synchronization mode.
TimeP: Viewing, Selecting, and Configuring
2
Time Protocols
9-21