Overview - ProCurve 2910al-24g Management And Configuration Manual

Note On Connecting
Transceivers to
Fixed-Configuration
Devices

Overview

This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■ Enable/Disable
Mode (speed and duplex)
■
■ Flow Control
■ Broadcast Limit
Friendly Port Names
■
■ Uni-directional Link Detection (UDLD)
Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Features
Feature
viewing port status
viewing transceiver status
configuring ports
configuring ProCurve auto-mdix
If the switch either fails to show a link between an installed transceiver and
another device, or demonstrates errors or other unexpected behavior on the
link, check the port configuration on both devices for a speed and/or duplex
(mode) mismatch.
■ To check the mode setting for a port on the switch, use either the Port
Status screen in the menu interface (page 10-4) or show interfaces brief in
the CLI (page 10-8).
To display information about the transceivers installed on a switch, enter the
show tech transceivers command in the CLI (page 10-12).
Default Menu
n/a page 10-4
n/a n/a
page 10-7
Port Status and Configuration
Overview
CLI Web
page 10-8 page 10-21
page 10-12 page 10-21
page 10-13 page 10-21
page 10-18
10-3