Log Set Installation - Rinnai Neo RIB2311N Installation Manual

Log set installation

The granule pack and log set, consisting of five log pieces, comes packaged inside the
appliance. The glass retainer will need to be removed before installing the granules and
log set. Use extreme care when handling the log pieces, they are made from a fragile
material and will damage easily.
It is important to position the pieces in the order shown below. Incorrect
placement can create carbon build-up and affect performance. Malfunctioning
due to improper log placement is not covered by warranty.
The unit must never be used with broken logs or other burn media (except the
Neo granules).
1. Check to ensure the ports of the main burner
are clean and clear of any particles and all
packaging.
3. Select the short straight log with the single
locating pin and place onto the metal tabs
at the left and rear of the burner box—will
touch the burner box walls when correctly
positioned.
2
5. Select the longest log and line up the hole with
the pin of log 1. When correctly located this
log will be touching the burner box walls and
resting on log 1.
1
4. Select the thinner 'Y' log and fit into position
1
6. Locate the final bowed log and line up the hole
4
2. Select the thicker 'Y' log and fit into position
by lining up the two pin holes onto the two
pins of the locating bracket that is fixed to the
centre of the main burner.
by linking up the two pin holes onto the two
pins of the first two logs. Ensure this log is
seated all the way down until in touches logs 1
and 2.
2
with the pin bracket to the right of the burner,
and locate the front of the log onto the stop
bracket. When correctly positioned it will be
touching both brackets, log 4, and the right
burner box wall.
4
1
3
1
5
Neo installation guide: 11906-F 06-14 | 17