Product Composition - Mitsubishi Electric FX2N-10GM User Manual

Melsec-f fx2n
Hide thumbs Also See for FX2N-10GM:
Table of Contents

Advertisement

4. Product composition

4.1 Each part name
The name and description of each part of the FX
4.2 Operation display
The state of FX
-10GM is displayed by LED.
2N
Name of LED
LED lights when power is supplied. If LED is not lit, check power supply voltage and
POWER
current.
LED lights when accepting an axis instruction.
READY
During pulse output or when an error occurs, the LED is off.
ERROR
LED is lit or blinks when an error occurs in the positioning drive of FX
CPU error. Incompatible system configuration, excess noise, etc. (Mixing foreign body,
CPU-E
and influence of noise, etc.)
4.3 I/O connector
The pin array of the I/O connector is as follows.
All terminals with identical names are shorted internally. (Ex. COM1-COM1, VIN-VIN, etc.)
Do not wire " • " terminals.
Refer to the FX
-10GM, FX
2N
4.4 Power supply connector
The power to the FX
2N
The ground of the FX
FX
-20GM HARDWARE PROGRAMMING MANUAL for details wiring instruction.
2N
Red +
-
Black
Green
(Ground)
FX
-100MPCB
2NC
4.5 Connection with PLC
Refer to the FX
-10GM, FX
2N
system configuration.
CON1
X0
START
X1
STOP
X2
ZRN
FWD
X3
RVS
Y0
Y1
DOG
Y2
LSF
Y3
LSR
COM1
COM1
Y4
Y5
-20GM HARDWARE PROGRAMMING MANUAL for wiring information.
2N
-10GM is supplied with the special power supply cable attached to the product.
-10GM and the servo amplifier is a common ground. Refer to the FX
2N
FX
-10GM
2N
-20GM HARDWARE PROGRAMMING MANUAL for details concerning the
2N
-10GM are explained below.
2N
Operation indicator LED
MANU/AUTO switch
Connector for programming tool
I/O display
Connector for PLC extension block
Hook for DIN rail installation
Connector for motor amplifier: CON2
Connector for I/O: CON1
Connector for power supply
Connector for PLC
Content
SVRDY
COM2
CLR
COM3
COM5
The pin number of the
power supply connector
of FX
-10GM
2N
1
2
3 Ground
CON2
SVEND
COM2
PG0
COM4
RP
FP
VIN
VIN
VIN
VIN
COM5
ST1
ST2
Install a safety circuit outside of
FX
-10GM so that the entire
2N
system may work safety when
the external power supply fails.
-10GM.
2N
-10GM,
2N

Advertisement

Table of Contents
loading

Table of Contents