Table of Contents
Advertisement
TRANSPORTATION AND STORAGE
PRECAUTIONS
•
The product is a precision instrument. During transportation, avoid impacts larger than those
specified in Section 5.2 by using dedicated packaging boxes and shock-absorbing palettes.
Failure to do so may cause failures in the product.
After transportation, verify operation of the product and check for damage of the mounting part, etc.
1. Reference manual
Refer to the under mentioned manual for details about product installation, and programming.
1) FX
-10GM, FX
2N
2N
The installation of FX
2) E-20TP-E OPERATION MANUAL
The operation of the input of the program which uses E-20TP-E and the monitor and the test is
explained.
3) FX-PCS-VPS/WIN-E SOFTWARE MANUAL
The operation program is input using the FX-PCS-VPS/WIN-E software. This manual explains the
operation of the monitor and test functions.
4) FX-PCS-KIT-GM-EE SOFTWARE MANUAL
The program is input via the FX-PCS-KIT-GM-EE. The manual explains the operation of the monitor
and test functions.
The manual in 1) is not included with the product. Please request from the shop where the units was pur-
chased if required.
The manuals in 2), 3) and 4) are included with the product.
2. Outline of the unit
The FX
-10GM positioning controller (hereinafter call FX
2N
that enables the positioning control of a stepping motor or a servo motor via the drive unit.
•
One FX
-10GM can control 1 axis.
2N
•
Both dedicated positioning language (cod instructions) and sequence language (basic instructions
and application instructions) are available.
•
A pulse generator can be connection.(The manual pulse generators must be an open collector output
type.)
•
The zero return operation at each start can be omitted with a servo amplifier with the absolute position
(ABS) detection function.
•
The FX
-10GM can be used alone.
2N
When an FX
-10GM is connected with an FX
2N
troller (here after call PLC), the positioning data can be read/written.
When connecting to an FX
When connecting to an FX
3. External dimensions
-20GM HARDWARE PROGRAMMING MANUAL
-10GM and FX
2N
2N
PLC, the FX
2NC
PLC, the FX
3UC
-20GM and wiring and the instructions are explained.
-10GM or 10GM) is a pulse chain output unit
2N
/FX
/FX
2N
2NC
3U
-CNV-IF must be used.
2NC
-CNV-IF or FX
2NC
3UC
/FX
series Programmable logic con-
3UC
-1PS-5V must be used.
Din rail width: 35mm
Weight: approx.0.3kg
Dimensions mm(inch)
Advertisement
Table of Contents
