Troubleshooting Table - Poulan Pro 115153026 Instruction Manual

TROUBLESHOOTING TABLE

WARNING:
Always stop unit and disconnect spark plug before performing all of
the recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
Engine will not
1. Ignition switch off.
start or will run
2. Engine flooded.
only a few
seconds after
3. Fuel tank empty.
starting.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
1. Idle speed requires
Engine will
adjustment.
not idle
2. Carburetor requires
properly.
adjustment.
Engine will not 1. Air filter dirty.
accelerate, 2. Spark plug fouled.
lacks power, 3. Chain brake engaged.
or dies under 4. Carburetor requires
a load. adjustment.
Engine 1. Too much oil mixed with
smokes gasoline.
excessively.
1. Idle speed requires
Chain moves
adjustment.
at idle speed.
2. Clutch requires repair.
REMEDY
1. Move ignition switch to ON.
2. See "Difficult Starting" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug and regap.
3. Disengage chain brake.
4. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
19