Basic Functions For Remote Engine Start - Mazda C960 V7 620 User Instructions

6. Basic functions for Remote Engine Start

Engine Start & Stop Function
The remote control is equipped with
engine start, engine stop and
automatic stop (set with timer)
functions. In addition, the engine
start operation will perform when
conditions outlined on page 14 are
satisfied. The air conditioner /
heater can be turned on beforehand
so the cabin of the vehicle can be
cooled or heated ahead of time.
Rear Defrost Function
The rear defrost turns on in the
following situations.
• When the cabin temperature is 5ºC
(41ºF) or less, 7 seconds after the
engine start operation performed on
the Remote Engine Start.
• When the rear defrost operation is
performed on the remote control.
ADVICE
The internal temperature of the vehicle cabin varies slightly depending on the
installed location of the controller.
The rear defrost will automatically stop when the engine stops.
The rear defrost will automatically stop after 15 minutes of operation on some
vehicle models.
When the cabin temperature falls to 5
engine start, the rear defrost will not turn on automatically.
The rear defrost cannot be turned off using the remote control.
On some vehicle models, dash light does not turn on when the rear defrost is
turned on with the Remote Engine Start.
Engine start → p.14
Engine stop → p.15
Directions for rear defrost operation
on remote control → p.19
º º
C (41 F) or less after 7 seconds from the
10
START