Table of Contents
Advertisement
ADJUSTING SLIDING FIT BETWEEN
M O VABLE TABLE AND BASE
CAUTION: DISCONNECT THE MACHINE FROM
THE POWER SOURCE.
If it ever becomes necessary to adjust the sliding fit
between the movable table and the base, turn nut (A)
Fig. 18, clockwise to increase or counterclockwise to
d e c r e a s e t h e s l i d i n g f i t . This adjustment should not be
t o o t i g h t t h a t i t r e s t r i c ts t h e r o tating movement of the
t a b l e o r t o o l o o s e t h a t i t a ff e c ts the accuracy of the saw.
ADJUSTING FENCE 90 DEGREES
TO BLADE
CAUTION: DISCONNECT THE MACHINE FROM
THE POWER SOURCE.
IMPORTA N T: BEFORE MAKING THIS ADJUST-
MENT MAKE CERTAIN THE BLADE IS SET AT 0
DEGREES
TO THE TABLE.
ADJUSTING
0
AND
POSITIVE STOPS.
1 . DISCONNECT THE SAW FROM THE POWER
SOURCE.
2 . Rotate the movable table so that the blade is 90
degrees to the fence and the positive stop for the 0
degree mark on the scale is engaged.
3 . Using a square (A) Fig. 19, place one end of the
square against the front of the fence (B) and the other
end against the blade (C), with the blade in the down
position, as shown. Check to see if the fence is 90
degrees to the blade.
4 . If an adjustment is necessary, t h e f e n c e ( B ) F i g . 1 9 ,
can be adjusted by loosening the two screws, shown at
( D ) , t h a t a t tach the fence to the base, using wrench
supplied. Adjust the fence (B) as required and tighten
the two screws (D).
5 . A fter you are sure the fence is 90 degrees to the
blade, adjust the cursor (F) Fig. 20, so the pointer is
aligned with the 0 degree mark on the scale by
loosening screw (G), adjusting cursor (F) and tightening
screw (G).
TABLE HAZARD A R E A
W ARNING: THE A R E A INSIDE THE TWO RED
LINES
(A)
FIG.
DESIGNATED AS A HAZARD
PLACE
YOUR HANDS INSIDE THIS A R E A
WHILE THE TO O L IS BEING OPERATED.
SEE
SECTION
45
DEGREE
BEVEL
21,
ON
THE
TABLE
ZONE.
NEVER
B
D
F
A
IS
9
A
Fig. 18
C
A
Fig. 19
G
Fig. 20
A
Fig. 21
Hide quick links:
Advertisement
Table of Contents
