Porter-Cable 3807 Instruction Manual page 6

MOVING CUTTINGHEAD
TO THE REAR POSITION
1 . MAKE CERTAIN THE MACHINE IS DISCON-
NECTED FROM THE POWER SOURCE.
2 . Carefully remove cable tie (A) Fig. 4, which is
holding the cuttinghead in the down position.
3 . To move the cuttinghead (D) Fig. 5, to the rear
position, loosen lock knob (E) and push cuttinghead (D)
t o t h e r e a r p o s i t i o n . Then tighten lock knob (E) Fig. 6.
4 . Fig. 6, illustrates the cuttinghead locked in the rear
p o s i t i o n .
RAISING THE CUTTINGHEAD
1 . While holding the cuttinghead (A) Fig. 7, down, pull
out and rotate cuttinghead lock knob (B) 90 degrees
u n t i l p i n ( C ) F i g . 8 , i s i n t h e h o r i z o n tal position as shown.
The cuttinghead can then be raised.
2 . Fig. 9 illustrates the cuttinghead (A) in the raised
p o s i t i o n .
3 . W ARNING: Cutterhead lock knob (B) Fig. 7, is
designed to lock the cutterhead in the down position for
only storage or carrying. Never operate saw with the
cutterhead in the lock down position.
C
B
A
Fig. 4
Fig. 8
E
E
A
6
Fig. 5
Fig. 6
A
B
Fig. 7
Fig. 9
D