Tool Storage - Porter-Cable 3807 Instruction Manual

A
A
A
A A
Fig. 35 Fig. 36
TO O L STO R A G E
A clip is provided on the rear of the saw and provides a convenient
storage area for wrench (A) Fig. 35, as shown.
FASTENING THE SAW TO A W O R K B E N C H
Before operating the saw, make sure it is firmly mounted to a workbench
or other supporting surface. Four holes (A) Fig. 36, are provided for
fastening the saw to a supporting surface.
USING THE SAW ON SAW HORSES
Fig. 37 illustrates the saw placed for use on saw horses. Notches in the
front and rear of the mounting feet are designed to fit conveniently on saw
horses.
Fig. 37
USING SAW WITH
2 X 4 EXTENSIONS R
S
Fig. 38 illustrates the saw being
P
used with 2 x 4 extensions.
Note that notches in the front
and rear of the mounting feet T
(K) are designed to fit and
P
fasten to the top of the two 2 x
4 s ( P ) . The length of the two 2
R
x 4 s (P) can vary depending on
your preference. The distance
S
P
f r o m t h e t o p o f t h e 2 x 4 s ( P ) t o
K
the saw ta b l e i s 3 1 " . This
...
2
enables you to nail or fasten
P
s tandard 2 x 4 s ( R ) t o t h e 2 x
4 s (P), as shown. The top of K
t h e 2 x 4 s ( R ) w i l l t h e n b e i n
alignment with the saw ta b l e ,
providing support for long
workpieces. If desired, fence
extensions (S) made of 2 x 2 s
can be aligned with fence (T)
and bolted to 2 x 4 s ( R ) .
Fig. 38
13