Replacement Of Consumables - Epson ActionLaser 1600 Service Manual

Maintenance

Replacement of Consumables

This printer uses consumable imaging cartridge S051016. The life of this
cartridge is 6000 pages when printing on letter-size pages with a 5% print ratio.
If printed images become faint, remove the cartridge and gently shake it. This will
distribute the toner and may make the images darker. If the image is still too
light, replace the imaging cartridge. The procedure for changing the imaging
cartridge is described below.
Imaging Cartridge Replacement
1.
Gently open the upper unit and remove the imaging cartridge by pulling it out.
2. Dispose of the used imaging cartridge.
3. While holding the new imaging cartridge horizontally, gently shake it a few
times to distribute the toner evenly.
4. Set the imaging cartridge on a clean, flat surface. Firmly grip the tab on the
left side of the cartridge. Pull the clear seal all the way out with firm, even
pressure, as shown
Figure 6-3. Removing the
Imaging Cartridge
5. Shake the imaging cartridge again.
6. Insert the imaging cartridge into the printer by placing the pins on each side of
the cartridge into the grooves inside the printer. Slide it gently into the
opening until it stops. Close the upper unit.
6-4
Figure 6-4. Shaking the Imaging
Cartridge
EPSON ActionLaser 1600 Service Manual