Fusing Unit Disassembly
This section describes how to remove the paper exit sensor, heater lamp, cleaning,
lower fusing roller, and upper fusing roller.
1. Remove the fusing unit. (Refer to page 3-22.)
Remove the paper exit sensor.
2.
Remove 2 CC (M3 x 6) screws for the side covers, and remove the side covers
3.
Do not touch the class surface of the lamn with vour bare hands.
Remove 2 CC (M3 x 6) screws on the heater lamp support plate, and remove
4.
the heater lamp support plate.
Remove the heater lamp.
5.
Figure 3-19. Disassembling the Fusing Unit 1
EPSON ActionLaser 1600 Service Manual
Caution
Disassembly and Assembly
3-23