Table of Contents
Advertisement
8.
If removed, do the following:
a. Install the air baffle (Installing the air baffle on page 43).
b. Install the processor mezzanine tray (Installing a processor mezzanine tray on page 87).
c. Install the 2P pass-through performance board (Installing a 2P pass-through performance board
on page 88).
9.
Install the access panel (Installing the access panel on page 41).
10. Install the server into the rack (Installing the server into the rack on page 34).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Powering up the server on page 38).
To configure the memory mode, use the BIOS/Platform Configuration (RBSU) in the System Utilities.
If a DIMM failure has occurred, see "Systems Insight Display combined LED descriptions on page 12."
Power supply options
The server supports installation of two or four of the following Flex Slot power supplies:
•
HPE 800W Flex Slot Platinum Hot-plug Power Supply
•
HPE 800W Flex Slot Titanium Plus Hot-plug Power Supply
•
HPE 800W Flex Slot Universal Hot-plug Power Supply
•
HPE 800W Flex Slot Hot-plug Battery Backup Power Supply
•
HPE 1600W Flex Slot Platinum Plus Hot-plug Power Supply
Population rules
The power supplies are supported horizontally for redundancy. Observe the following when installing power
supplies:
Two power supply configuration
•
Install the power supplies into power supply bays 1 and 2.
•
Connect the power supplies to separate AC circuits for redundancy.
Four power supply configuration
Power supply options
91
Advertisement
Table of Contents
