Table of Contents
Advertisement
Prerequisites
Before installing this option, be sure that you have the following:
•
T-10 Torx screwdriver
•
The components included with the hardware option kit
Procedure
1.
Power down the server (Power down the server on page 38).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack (Extend the server from the rack on page 38).
•
Remove the server from the rack (Removing the server from the rack on page 39).
4.
Remove the access panel (Removing the access panel on page 40).
5.
Remove the secondary riser cage blank.
6.
Remove the power cage blank.
Installing hardware options
71
Advertisement
Table of Contents
