Installing And Removing Simms - Kyocera Mita FS-3700 Manual

1.7. Memory Expansion Installation

Installing and Removing SIMMs

Installing SIMMs
Insert the SIMM into the socket as shown
right.
1. Insert the connector end of the SIMM
into the socket.
2. Carefully push the board upright until it
snaps into place. Make sure that the
catches at the ends of the socket fit into
the holes at the ends of the SIMM board.
Removing SIMMs
To remove a SIMM, carefully pull the end
catches slightly outwards and tilt the SIMM as
shown, then pull the SIMM out of the socket.
Reverse the procedure under Withdrawing the
Main Circuit Board from the Printer to put the
main circuit board back into the printer.
1-26
SIMM
Catch
Catch
Socket