Comtech EF Data CDM-570 Installation And Operation Manual page 380

CDM-570 Satellite Modem with Optional IP Module
F.2.4.5 (ODU,ENABLE, CONFIG,TRANSMITTER) ATTEN (Attenuation)
ODU Tx Attenuation:
15 dB
The user is prompted to edit the transmit attenuation. This is accomplished by selecting
the digit to be edited, using the ◄ ► keys. The value of the digit is then changed using
the ▲ ▼ keys. The user then presses ENT.
F.2.4.6 (ODU,ENABLE,CONFIG,TRANSMITTER) OUTPUT
KST Tx Output:
Off
The user is prompted to select either ON, OFF, or WARM using the ◄ ► keys, then
press ENT.
•
•
•
F.2.4.7 (ODU,ENABLE,CONFIG,TRANSMITTER) HPA
HPA:
The user may select a parameter using the
F.2.4.8 (ODU, ENABLE,CONFIG,TRANSMITTER) STATE
KST HPA State:
On
Note: If the HPA power is Off, it cannot report errors, answer messages, provide serial
numbers, etc.
F.2.4.9 (ODU,ENABLE,CONFIG, TRANSMITTER) FAULT-LOGIC
HPA Fault Logic: Summary
No-Summary
The user may select from the options shown, using the ◄ ► keys, then press ENT.
This controls whether or not HPA fault will activate the SUMMARY FAULT RELAY.
◄ ►,▲ ▼,
(
◄ ►,E
On Warm (
WARM is OFF, if COLD.
WARM is ON, if warm and NO FAULTS
FAULTS present, stays WARM and OFF indefinitely
State Fault-Logic
◄ ►,E
(
◄ ►,E
Off (
◄ ►,E
(
Addendum B- 18
ENT)
NT)
NT)
◄ ►
keys, then press ENT.
NT)
NT)
ODU Operation