Assembling The Plane; Horizontal Tail Installation - FMS 2000MM Beaver DHC-2 Operating Manual

Horizontal Tail Installation

1.Slide the horizontal tail tube into the hole in rear of the fuselage
2.Install the 2 piece（left and right）horizontal tail as shown. Ensure the control horn faces down.
3.Install 4 screws in the front and rear holes in the button of the horizontal tail.
4.Attach the ball link to the elevator control horn's outermost hole using the included nut and screw.
5. Carefully apply CA to the base and side of the rear Horizontal stabilizer
6. Carefully place the Vortex Generator into the pocket
fig1
fig1
fig4
fig5
5
HKM3.0×10mm
fig2
fig2
fig3
fig5
fig6
Required Adhesives:
Foam Safe Medium CA