Configuring Msdp Md5 Password Authentication - Cisco XR12000 Series Configuration Manual

Configuring MSDP MD5 Password Authentication

Command or Action
Configuring MSDP MD5 Password Authentication
SUMMARY STEPS
1. configure
2. router msdp
3. peer peer-address
4. password {clear | encrypted} password
5. Use the commit or end command.
6. show mfib [vrf vrf-name] [ipv4 | ipv6] hardware route {* | source-address | group-address[/prefix-length]}
location node-id
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/0/CPU0:router# configure
Step 2
router msdp
Example:
RP/0/0/CPU0:router(config)# router msdp
Step 3
peer peer-address
Example:
RP/0/0/CPU0:router(config-msdp)# peer 10.0.5.4
Step 4 password {clear | encrypted} password
Example:
RP/0/0/CPU0:router(config-msdp-peer)# password
Cisco IOS XR Multicast Configuration Guide for the Cisco XR12000 Series Router, Release 5.1.x
86
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
• Cancel—Remains in the configuration mode, without committing the
configuration changes.
Purpose
Enters global configuration mode.
Enters MSDP configuration mode.
Configures the MSDP peer.
Configures the password.
OL-30405-02