Mitsubishi QD75M1 User Manual page 164

5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Servo amplifier setting invalid (
MR- MR- MR-
H-BN H-BN4 J2-B
2: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75), then switch it on
again to make that parameter setting valid.
4: You cannot change parameter "Serial communication response delay time setting" and "Serial communication baud rate setting".
5 : Don't use to the parameter (normal). Don't change setting value "Default value" by any means.
: Invalid, : Valid)
Value set with sequence program
MR- MR- MR-
J2S-B J2-Jr J2M-B
4
1:
H
Serial communication
baud rate selection
Serial communication
response delay time selection
Encoder output pulse setting selection
OPR set condition selection
is used to set up the setting
value. (Hexadecimal)
0 to 50000
0 to 1000
0 to 65535
5 - 77
MELSEC-Q
Setting value buffer memory
address
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0000 30133 30233 30333 30433
H
0 30134 30234 30334 30434
980 30136 30236 30336 30436
4000 30138 30238 30338 30438