Chapter 19: Ip Configuration: Ripv2; Overview - Cisco 500 Series Administration Manual

IP Configuration: RIPv2
NOTE

Overview

NOTE
Cisco 500 Series Stackable Managed Switch Administration Guide
This section describes the Routing Information Protocol (RIP) version 2 feature.
It covers the following topics:
• Overview
• How Rip Operates on the Device
• Configuring RIP
RIP is supported in the following devices:
- SG500X/SG500XG in standalone stacking mode.
- SG500X/SG500XG in advanced hybrid stacking modes in Layer 3.
Routing Information Protocol (RIP) is an implementation of a distance-vector
protocol for local and wide-area networks. It classifies routers as either active or
passive (silent). Active routers advertise their routes to others; passive routers
listen and update their routes based on advertisements, but do not advertise.
Typically, routers run RIP in active mode, while hosts use passive mode.
The default gateway is a static route and it is advertised by RIP in the same way as
all other static routers, if it is enabled by configuration.
When IP Routing is enabled, RIP works fully. When IP Routing is disabled, RIP
works in the passive mode, meaning that it only learns routes from the received
RIP messages and does not send them.
The IP Routing control is available on the SG500X/ESW2-550X models only. To
enable IP Routing, go to Configuration > Management and IP Interface > IPv4
Interface page.
The device supports RIP version 2, which is based on the following standards:
19
403