Cisco 500 Series Administration Manual page 153

9
151
The time interval between notifications is entered in the Topology Change
SNMP Notification Interval field in the LLDP Properties page. Define SNMP
Notification Recipients by using the SNMP > Notification Recipient v1,2
and/or SNMP > Notification Recipient v3 page.
• Selected Optional TLVs—Select the information to be published by the
device by moving the TLV from the Available Optional TLVs list. The
available TLVs contain the following information:
- Port Description—Information about the port, including manufacturer,
product name and hardware/software version.
- System Name—System's assigned name (in alpha-numeric format). The
value equals the sysName object.
- System Description—Description of the network entity (in alpha-
numeric format). This includes the system's name and versions of the
hardware, operating system, and networking software supported by the
device. The value equals the sysDescr object.
- System Capabilities—Primary functions of the device, and whether or
not these functions are enabled on the device. The capabilities are
indicated by two octets. Bits 0 through 7 indicate Other, Repeater, Bridge,
WLAN AP, Router, Telephone, DOCSIS cable device, and station
respectively. Bits 8 through 15 are reserved.
- 802.3 MAC-PHY—Duplex and bit rate capability and the current duplex
and bit rate settings of the sending device. It also indicates whether the
current settings are due to auto-negotiation or manual configuration.
- 802.3 Link Aggregation—Whether the link (associated with the port on
which the LLDP PDU is transmitted) can be aggregated. It also indicates
whether the link is currently aggregated, and if so, provides the
aggregated port identifier.
- 802.3 Maximum Frame Size—Maximum frame size capability of the
MAC/PHY implementation.
Management Address Optional TLV:
• Advertisement Mode—Select one of the following ways to advertise the IP
management address of the device:
- Auto Advertise—Specifies that the software automatically chooses a
management address to advertise from all the IP addresses of the
device. In case of multiple IP addresses, the software chooses the lowest
Cisco 500 Series Stackable Managed Switch Administration Guide
Administration: Discovery
Configuring LLDP