Defining Snmpv3 Notification Recipients - Cisco 500 Series Administration Manual

SNMP
Notification Recipients
STEP 5
STEP 1
Cisco 500 Series Stackable Managed Switch Administration Guide
• Retries—Enter the number of times that the device resends an inform
request.
• Community String—Select from the pull-down the community string of the
trap manager. Community String names are generated from those listed in
the Community page.
• Notification Version—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a
single version enabled at a time.
• Notification Filter—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the Notification
Filter page.
• Filter Name—Select the SNMP filter that defines the information contained
in traps (defined in the Notification Filter page).
Click Apply. The SNMP Notification Recipient settings are written to the Running
Configuration file.

Defining SNMPv3 Notification Recipients

To define a recipient in SNMPv3:
Click SNMP > Notification Recipients SNMPv3.
This page displays recipients for SNMPv3.
• Informs IPv4 Source Interface—Select the source interface whose IPv4
address will be used as the source IPv4 address in inform messages for
communication with IPv4 SNMP servers.
• Traps IPv4 Source Interface—Select the source interface whose IPv6
address will be used as the source IPv6 address in trap messages for
communication with IPv6 SNMP servers.
• Informs IPv6 Source Interface—Select the source interface whose IPv4
address will be used as the source IPv4 address in inform messages for
communication with IPv4 SNMP servers.
• Traps IPv6 Source Interface—Select the source interface whose IPv6
address will be used as the source IPv6 address in trap messages for
communication with IPv6 SNMP servers.
29
648