Establishing Connections - Siemens SINAMICS G120 Hardware Installation Manual

Connecting-up
5.2 Connecting the line and motor cable at the inverter
5.2.3.1

Establishing connections

Procedure
Proceed as follows to establish the connections:
1. Ensure that the device is in a no-voltage condition and the DC link is discharged.
2. Establish the connections as described in the following sections.
This means that you have established the connections.
Connections, frame sizes FSD ... FSF
You must remove the covers from the connections in order to connect the line supply and
motor cables to the inverter.
Figure 5-4
In addition, for frame sizes FSD and FSE, release the two terminal screws on the connections
for the motor and remove the dummy plug.
For frame size FSF you must breakout the openings from the connection cover for the power
connections. Use side cutters or a fine saw blade.
48
2
1
Remove the connection covers
3
1
Hardware Installation Manual, 11/2016, A5E37800827C AB
2
PM240P-2 Power Modules