Bobbin Winding - Pfaff creative icon User Manual

Bobbin Winding

All types of thread, including specialty threads such as
invisible or other stretchy threads, metallic or flat
metallic threads, should be wound directly from the
auxiliary spool pin without passing the needle and
presser foot.
Note: Always wind specialty threads at lower speed.
1. Place a thread spool on the auxiliary spool pin.
Using both hands, pull the thread behind the right
clip on the telescopic thread guide (A). The thread
should run from right to left.
2. Bring the thread through bobbin winding thread
tension guide (B) from back to front and to the left.
Bring the thread through bobbin winding thread
guide (C) as illustrated.
For some specialty threads, following the
normal threading path will result in a bobbin
that is wound too tight. If this happens, bypass
thread tension (B) to reduce the amount of
tension on the thread. Pull the thread from
thread guide (A) directly to the bobbin instead.
3. Thread through the slot in the bobbin (D) from the
inside to the outside.
Place the bobbin on the bobbin spindle (C). The
bobbin only fits on one way, with the logo facing
out.
The bobbins included are designed especially
for your creative icon™ machine. Do not use
bobbins from other machine models.
4. Push the bobbin winding lever (E) towards the
bobbin. A pop-up appears on screen. To adjust
winding speed drag the slider. Hold the thread end
firmly when starting to wind. Touch the play
button in the popup window and let the thread
wind a few turns. Touch the pause icon and cut the
loose thread end close to the bobbin. Press play
again.
5. When the bobbin is full, the bobbin winding lever
will move back and the winding will stop
automatically. The pop-up message closes. Remove
the bobbin and cut the thread using the bobbin
winding thread cutter (F).
42
A
C
B
D
F E