Chapter 3
Communication Ports
4.
Insert the new module into the slot.
Figure 27: Installing a Module
1. Chassis
2. Module
5.
Tighten the screws to secure the module.
6.
If necessary, install the device in the rack.
7.
Connect power to the device.
Section 3.6.2
Removing a Module
Once a module is removed, all the features associated with the module are hidden or disabled in the operating
system.
To remove a module, do the following:
1.
Make sure power to the device has been disconnected and wait approximately two minutes for any
remaining energy to dissipate.
2.
If the device is installed in a rack, remove it from the rack.
3.
Loosen the screws that secure the module.
4.
Pull the module from the chassis to disconnect it.
26
1
2
3
3. Screw
RUGGEDCOM RX5000
Installation Guide
Removing a Module